Telegram Contract Scanner Bot: Check Any Solana Token Address in 2026
Short answer A Telegram contract scanner bot reads any address pasted in your group chat — sell function, launch flags, deployer history. Setup takes one tap in 2026.
A Telegram contract scanner bot reads a contract address the moment someone pastes it into a group chat and replies with what the token actually is. PumpPill's is @PumpPill_Group_Scan_Bot. Add it to any Telegram group and from that point on, every address anyone drops gets answered in the chat — whether the token can be sold, what is flagged on the launch, how far it has run from where it was first logged, and a link to the full read.
Nobody in the group has to sign up for anything. It answers in a direct message too.
That is the whole pitch, and it takes about as long to explain as it does to set up. The rest of this post is about why the gap it fills is wider than it looks, and where it stops.
Why Telegram groups are the right place for a contract check
Trading happens in group chats. Addresses get pasted there, decisions get made there, and the loudest person in the room usually gets the benefit of the doubt there. A check that lives anywhere else is a check that does not get run.
Block explorers are accurate and slow. Scanner sites are accurate and somewhere else. Both require someone to leave the conversation, which means the answer arrives after the conversation has already moved on. In a fast market, an answer that arrives late is the same as no answer.
A bot in the chat closes that gap because it answers in the place the question was asked, in the seconds after it was asked, without anyone leaving.
The problem: four minutes of work nobody does
Every trading group has the same moment. Someone pastes an address. Three people ask "is this safe?" Two people say "looks fine." Nobody has actually looked.
Looking properly means opening a block explorer, finding the pair, checking whether liquidity is locked, checking whether the sell function works, and looking up what the deployer shipped before. That is four minutes of work, and the token has moved before anyone finishes.
So the group does the fast version: someone glances at the chart and says it looks fine. That is not a check. It is a vibe with a delay.
The cost of that shortcut is asymmetric. If the read was fine, you lost nothing. If the read was wrong in a specific way — a disabled sell function, a launch supply held by one entity, a deployer with a trail of dead tokens — you cannot trade out of it. You are not down on paper. You are stuck.
What the bot answers when an address is pasted
The reply covers the properties that decide whether a position can go wrong in a way you cannot exit:
Can it be sold. The single most important property of a token and the one most often assumed. A contract can permit buying and block selling, tax the sell to zero, or let one address flip that switch later. Price does not tell you any of this.
What is flagged on the launch. Where the launch supply went, whether it was spread across wallets that are actually one buyer, whether liquidity is locked, and who is able to take it back. This is bundle and supply analysis, not a chart read.
How far it has run. Measured from the market cap when the token was first logged, not from a number typed by whoever is promoting it. A token that has already done most of its move is a different proposition from one that has not moved, and the two look identical on a chart you are seeing for the first time.
What the operator shipped before. Deployers have histories. The address launching this token has usually launched others, and what happened to those is a matter of record. Promoter cross-referencing against known scam networks runs through X-Intel — the same engine that flags repeat rug pullers before a buy.
Underneath the reply sits the same pipeline that feeds the rest of the platform: 8 independent analysis engines working over every token that enters the queue, covering signal strength, bundle intelligence, scam detection, virality, memetic structure, whale tracking, funder track record and convergence detection.
Adding it to a group: a 30-second intro
Open t.me/PumpPill_Group_Scan_Bot?startgroup=true and pick your group from Telegram's list. That is the entire setup.
There is no configuration step, no API key to paste, and no per-member signup. Once it is in the group it answers for everyone in it — including the people who never installed anything and never asked for it.
It works on both Solana and Robinhood Chain addresses, and it recognises which chain an address belongs to without being told. If you would rather use it privately, message the bot directly and paste an address there.
That intro is deliberately short. The bot is not a dashboard, and it is not trying to be. It exists to answer one question fast, in the place where the question gets asked.
The live feed, in the open
Before you trust any scanner, watch what it publishes. Every signal PumpPill fires is written to a public board as it happens — no login, no delay.
Spend a week reading that feed before you act on anything in it. The pattern you are looking for is not a hot token. It is whether the reasoning holds up when the outcome is already known.
What makes this different from a chart link
Most bots that answer addresses in group chats return price, market cap and a link. That is a quote, not a check. Price tells you what people paid. It does not tell you whether you will be allowed to sell, and those are completely separate facts about a contract.
The distinction matters most exactly when it is most expensive. A token whose price is going up and whose sell function is disabled looks, on a chart, like the best thing in the group.
The second difference is the reference point. "Up 300%" is meaningless without saying up from what. A promoter quoting a multiple is quoting from a number they chose. The bot quotes from the market cap at the moment the token entered our records — fixed at the time it was logged, and not adjusted afterwards to flatter the number.
Using it well in a group
Let it answer before the group does. The value is in the ordering. If the bot's reply lands before opinions form, the conversation starts from what the contract is rather than from what the first confident person said. That is a cultural fix as much as a technical one.
Treat a clean read as permission to look, not permission to buy. A contract passing structural checks means the obvious ways to lose have been ruled out. It says nothing about whether anyone will want the token tomorrow. Most tokens with clean structure still go nowhere — that is the base rate, and no scanner changes it.
Check the pool size yourself. The read tells you about the contract. How much you can actually put in and get back out is a function of liquidity, and that is a number you should look at before sizing anything.
Read the flags, not just the verdict. A token can pass the sell check and still show concentrated launch supply. The detail is where the information lives.
From the read to the trade
Each reply ends with a Buy link that opens @PumpPill_Trade_Bot, a separate bot, with the same contract already loaded. There you can run the Scan again under the token card, pick a size, and buy with staged exits armed on the price you paid — without hunting for the address a second time.
The risk from the group read stays in front of you. The Buy link sits on every reply, whatever the read said. That is deliberate: the tool does not gate your decision, it informs it.
If you want the alert layer rather than the manual read, Telegram alerts fire the moment tracked wallets converge on a token, and the members board shows how the strategy tiers are structured.
What it does not do
It does not tell you what to buy. It has no opinion on whether a token will go up, and it will not produce one if you ask.
It does not catch everything. Contract-level checks catch contract-level problems. A token with clean structure, locked liquidity and a working sell function can still be abandoned by its team the following week, and no amount of reading the contract will tell you that in advance.
It does not replace looking at the pool. The scanner reads the token; the size of the position you can safely take is set by the liquidity, and that is your call.
It does not scan every launch on pump.fun. Intake is a curated set of high-signal alpha rooms — the tokens that reach the pipeline are the ones worth the compute, not the entire firehose.
The full product read on the site
The group bot is the fast version of a read that exists in full elsewhere. Paste any address into the scanner at /scan and you get the complete breakdown — launch structure, holder concentration, what kind of asset it is, the product score where one applies, and whether it is still trading at all.
The wider board at Discover surfaces both Solana and Robinhood Chain on one screen, with new drops, trending by engagement and tokens gaining value split into separate views. The user guide covers how each score is built and what the thresholds mean.
For wallets rather than tokens, the platform tracks a tier of high-performing whale wallets — 344 across all tiers — and traces the funder wallets behind every token in the pipeline. When a funder's tokens consistently outperform, that wallet gets auto-promoted to the watchlist. When it goes dark, the system traces upstream to find its replacement.
FAQ
How do I add the contract scanner bot to a Telegram group?
Open t.me/PumpPill_Group_Scan_Bot?startgroup=true, then pick the group from Telegram's list. There is no configuration step and no key to paste. Once it is in, it answers for every member automatically.
Does the bot work for both Solana and Robinhood Chain addresses?
Yes. It recognises which chain an address belongs to without being told, so you can paste either type into the same chat.
Can the bot tell me whether a token will go up?
No, and it will not pretend to. It reports what the contract permits, what is flagged on the launch, how far the token has run from its first logged market cap, and what the deployer shipped before. Direction is not something a contract read can produce.
What does it check that a chart link does not?
A chart link returns price and market cap — a quote. The bot returns whether the sell function works, where launch supply sits, whether liquidity can be pulled, and the deployer's track record. Those are separate facts about a contract, and they are the ones that determine whether you can exit.
Do I need an account to use it in a group?
No. The bot answers in the chat without any per-member signup. Alerts and the premium tier are separate — those live at /alerts.
The takeaway
A Telegram contract scanner bot is not a smarter chart. It is a different question asked at the right moment — in the chat, before opinions harden, with the answer already written by the time the second person says "looks fine."
Add it to your group first. Setup is one tap, and the next time someone pastes an address, the answer arrives before the argument does.
What the video says the full transcript, for reading or searching
The lesson is the method. The product is where you apply it.
Paste any Solana or Robinhood Chain contract into the PumpPill trade bot: you get the risk read first, then buy or sell in one tap, with limit orders and auto-sells.